
On most Florida horse farms, water comes from a well, and a well pump runs on electricity. When a storm knocks the power out, the pump stops, the pressure tank drains, and automatic waterers go dry. A horse can drink 10 gallons a day or more, more in the heat, so an outage that lasts a day or two quickly becomes a real problem.
The fix is a backup power setup that's planned ahead of time. Here's how it works.
Step 1: Know what you need to run
Start with a short list of the loads that matter most during an outage. On a farm that usually means:
- The well pump (the big one)
- A few barn lights and outlets
- Stall fans, if it's hot
- The refrigerator and a few circuits in the house
- Electric gates, if you rely on them
The well pump matters most for sizing. Pumps draw a large surge of current for a moment when they start, often several times their running load. A generator that can run the pump may still stall when the pump kicks on if it's too small. Your electrician should check the pump's nameplate and size the generator with that starting surge in mind.
Step 2: Choose portable or standby
Portable generator + inlet
A portable generator plugged into a properly installed inlet box and transfer switch (or interlock) is the most affordable option. When the power goes out, you roll the generator out, plug it into the inlet, start it, and switch over the circuits you want. It's manual, but it works well for many farms.
Standby generator + automatic transfer switch
A permanently installed standby generator runs on propane or natural gas and starts on its own within seconds of an outage. An automatic transfer switch moves your loads over without anyone needing to be home. It costs more, but if you travel, show, or simply can't afford to have the water stop, it's worth considering.
Never backfeed. Plugging a generator into a dryer outlet or a regular receptacle with a "suicide cord" can send power back out onto the utility lines and seriously injure line workers or anyone working on your system. It can also start a fire. A transfer switch or interlock prevents this, and it's required.
Step 3: Get it installed and permitted
A transfer switch or generator connection is permitted electrical work in Florida. A licensed electrician will:
- Figure out which circuits go on backup power
- Install the transfer switch or interlock and the generator inlet
- Run the right size wire for the generator
- Pull the permit and pass inspection
- Walk you through how to switch over safely
If your barn and well are on a separate service from the house, the setup may look a little different. That's a common situation on farms, and it's one we deal with often.
Step 4: Test it before storm season
Run the generator under load a few times a year, keep fresh fuel on hand (or keep the propane tank topped off), and make sure everyone on the farm knows how to switch over. The middle of a hurricane is the wrong time to read the manual for the first time.
The bottom line
If your horses depend on a well, plan for the power going out. A properly sized generator and transfer switch is a one-time project that keeps water flowing and protects the people working on the lines.
"When we unexpectedly needed to get our generator hooked up so we could run our well and make sure our horses had water, Matt came out after hours without hesitation."
Want your well on backup power?
We'll size it and install it right. Give us a call.